Matrix Amplification XT1000 Manual do Utilizador descarregar pdf (Página 5)

Q SERIES USER MANUAL 4

(3) Power Indicator

This indicator shows when the amplifier is on and is receiving power.

(4) Cooling Fan Outlet

Hot air exits here. Make sure the ventilation area behind cabinet is free from

obstruction and air flows freely, otherwise the amplifier is likely to enter protect

mode or in some extreme circumstances damage may occur.

(5) Input Signal Socket

This is a combined female XLR and 1/4" jack socket which allows connection to both 1/4”

instrument patch leads and industry standard Balanced XLR systems. Note these inputs are not

suitable for direct connection to instruments, the cabinet is intended to be driven by the use of a

suitable preamp/pedal.

CAUTION !

DO NOT connect the speaker driving output from other power amplifiers to this

input socket. It is not intended to be used in this manner, damage will occur !

(6) Power Connection and Fuse

Mains power is supplied to the amplifier by a standard 10 Amp IEC mains socket.

An appropriate mains lead is supplied with the amplifier. Also, the amplifiers fuse is installed

within the connector block, Should this need to be replaced, refit with same rating and type. If

unsure about any servicing procedures, please contact qualified service personnel. at the

speaker s

(7) External Loudspeaker Cabinet Link

In amplified mode, this connector block is intended to be used to connect another identical

un-amplified slave cabinet as needed. To prevent potential damage to equipment, only use

identical passive slave cabinets and ensure cable link chosen is suitable for carrying high power

speaker signals; if unsure, contact a suitably qualified engineer.

When the internal amplifier is operating, the above input should NOT be used under any

circumstances, it is intended for passive modes only. In the case of the amplified cabinet, these

are available when the amplifier is not connected to the mains supply or turned on. For further

information on how to use these modes, consult the Passive cabinet section of this manual.

CAUTION !

Whilst it is possible to use an external amplifier to power a cabinet which

also includes the amplifier module if needed, in the same manner as the

passive cab, the internal amplifier MUST be turned off and disconnected

from mains supply in order to ensure irreversible damage does not occur to

equipment.

REV.1.22 MATRIX AMPLIFICATION

1 2 3 4 5 6 7 8 9 10 11 12 13

Sem comentários

Matrix Amplification XT1000 Manual do Utilizador Página 5