Matrix Amplification XT1000 Manual do Utilizador descarregar pdf (Página 9)

Q SERIES USER MANUAL 8

5. Mono Loudspeaker Usage (Passive Cabinet):

For Mono (single channel applications) connect the speaker cabinet to the amplifier as

shown. Where chaining additional cabinets to the same amplifier channel is required, the Output

Link from the first cabinet can be used as shown above in grey.

When connecting one or more speakers to an amplifier ensure that the amplifier can handle

the load presented and that the configuration is properly matched for safe and optimal

performance. A Table of recommended combinations is provided on page 6.

If unsure about any aspect of using the loudspeaker system, consult with a suitably qualified

audio engineer.

The speaker cabinet is a Mono only device, under NO circumstances attach

multiple amplifier channels to the same cabinets connector block, otherwise poor

performance and damage to equipment being used is likely to occur.

For stereo applications please follow the instructions on the next page, using

two or more speaker cabinets.

Also note that series and series parallel connections cannot be used with this

cabinet due to the presence of an internal crossover splitting the signal for the

coaxial driver; poor performance will result.

CAUTION !

Whilst it is possible to use an external amplifier to power a cabinet which

also includes the amplifier module if needed, in the same manner as the

passive cab; This MUST be turned off and disconnected from mains supply

in order to ensure irreversible damage does not occur to equipment.

REV.1.22 MATRIX AMPLIFICATION

1 2 3 4 5 6 7 8 9 10 11 12 13

Sem comentários

Matrix Amplification XT1000 Manual do Utilizador Página 9